Skip to content
PounceFit
PTEN

Sum of skinfolds: how to track progress

By PounceFit Team · Updated on

Green skinfold caliper with a dial stored in its case
Photo: Navazob (CC BY 4.0), via Wikimedia Commons

Technical content for health and fitness professionals. It reproduces formulas and protocols published in the scientific literature, with the sources at the end of the page. It is not a recommendation and does not replace the judgment of the professional who runs the assessment.

The sum of skinfolds is the total, in millimeters, of the skinfolds measured in the assessment, used without going through an equation. It tracks change in the same client's subcutaneous fat over time without inheriting the error and bias of density equations (Heyward and Wagner, 2004). In sport, raw measurements like this are considered useful for tracking change (Ackland et al., 2012). The condition is to keep the same skinfolds, the same sites, the same caliper and, preferably, the same assessor.

The same skinfolds that go into the 7-site calculator work for the sum: the calculator shows the percentage, and the sum is the first step of the calculation.

Why use the sum of skinfolds instead of the percentage?

Every skinfold equation starts from the sum (or its logarithm) and adds assumptions: the population it was built on, age, the conversion of density to fat. Each assumption adds error. The IOC Medical Commission itself, in a position statement on body composition in sport, concluded that there is no universal gold-standard method and that, to track change, methods whose raw data reflect body composition remain useful (Ackland et al., 2012).

Vaquero-Cristóbal et al. (2020) applied four formulas (Kerr, Durnin and Womersley, Faulkner and Carter) to the skinfolds of 2,458 active adults. Mean body fat ranged from 10.7% to 28.4%, depending on the formula. Sums of skinfolds correlated well with all of them (r from 0.705 to 0.926). The sum therefore carries the information the formulas use, without the difference each one adds.

How to calculate the sum of skinfolds

Add the skinfolds in millimeters, using the mean (of two measurements) or the median (of three) for each site (Norton, 2018).

Most commonly used sums:

Sum Skinfolds Origin
7 skinfolds Chest, midaxillary, triceps, subscapular, abdominal, suprailiac and thigh Jackson and Pollock protocol sites, as described by ACSM
8 skinfolds Triceps, subscapular, biceps, iliac crest, supraspinale, abdominal, front thigh and medial calf ISAK restricted profile (Norton, 2018)
4 skinfolds Biceps, triceps, subscapular and suprailiac Durnin and Womersley protocol
3 skinfolds Chest, abdominal and thigh (men); triceps, suprailiac and thigh (women) Jackson and Pollock 3-site protocol

Sums with different skinfolds cannot be compared with each other. Nor can you compare an 8-site ISAK sum with a 7-site ACSM one, because the sites are not the same. See the differences in how to measure skinfolds.

Worked example

A female client assessed with the 7 skinfolds on two dates, with the same assessor and the same caliper (means, in mm):

Skinfold Assessment 1 Assessment 2
Chest 12.0 11.0
Midaxillary 14.5 13.5
Triceps 22.0 20.5
Subscapular 18.0 17.0
Abdominal 28.0 25.5
Suprailiac 20.0 18.5
Thigh 30.0 28.5
Sum 144.5 134.5

The sum dropped 10 mm, about 7%. The reading is direct: the subcutaneous fat measured at these sites decreased. There is no equation, age or conversion in the way.

To know whether 10 mm is more than the technique's error, use the assessor's technical error of measurement for each skinfold: with it, Norton (2018) shows how to build a confidence interval for the difference between two measurements.

Precautions when comparing the sum

  • Same assessor. There are systematic differences between assessors, even among the most experienced, so the ideal is the same assessor for measurements over time (Norton, 2018).
  • Same sites and same technique. A site displaced by a few centimeters already changes the skinfold (Norton, 2018).
  • Same conditions. Do not measure after a workout, sauna or hot shower (Norton, 2018).
  • Look at the skinfolds too. The sum can stay flat while one region shrinks and another grows. The per-skinfold table shows where the change happened.
  • Larger skinfolds err more. Measurement error tends to grow where the skinfold is larger (Perini et al., 2005), which weighs more on the sum for people with more fat.
  • The sum is not the percentage. It does not tell you how much of the weight is fat. When the percentage is needed, use an equation and keep the same one in every assessment (Vaquero-Cristóbal et al., 2020).

Sum and percentage in the same assessment

The two pieces of information complement each other: the percentage places the client against a reference, such as the table in ideal body fat percentage, and the sum shows the change with fewer assumptions. In PounceFit, body assessment software, the result of each skinfold assessment shows the sum in millimeters, and the client's record has a chart of the sum across assessments.

Frequently asked questions

What is the sum of skinfolds?

It is the sum, in millimeters, of the skinfolds measured in the assessment, without going through any equation. It is used to track change in the same client's subcutaneous fat over time (Heyward and Wagner, 2004).

Why use the sum instead of body fat percentage?

Because the percentage depends on the equation chosen, and different equations give very different values for the same person. In a study of 2,458 active adults, the formulas gave mean body fat from 10.7% to 28.4%, while sums of skinfolds correlated well with all of them (Vaquero-Cristóbal et al., 2020).

Is there a reference table for the sum?

There is no universal table. The sum depends on which skinfolds are included and where each is measured, so it is used mainly to compare the client with themselves. Comparisons with groups only make sense with the same sites and the same technique.

How much does the sum need to drop to be a real change?

More than the assessor's measurement error. The technical error of measurement, calculated from repeated measurements, allows you to build a confidence interval for the difference between two assessments (Norton, 2018). Differences smaller than that error may be just variation in technique.

Sources

  1. Ackland TR, Lohman TG, Sundgot-Borgen J, Maughan RJ, Meyer NL, Stewart AD, Müller W. Current status of body composition assessment in sport: review and position statement on behalf of the ad hoc research working group on body composition health and performance, under the auspices of the I.O.C. Medical Commission. Sports Medicine. 2012;42(3):227-249. doi:10.2165/11597140-000000000-00000
  2. Vaquero-Cristóbal R, Albaladejo-Saura M, Luna-Badachi AE, Esparza-Ros F. Differences in fat mass estimation formulas in physically active adult population and relationship with sums of skinfolds. International Journal of Environmental Research and Public Health. 2020;17(21):7777. doi:10.3390/ijerph17217777
  3. Heyward VH, Wagner DR. Applied body composition assessment. 2nd ed. Champaign: Human Kinetics; 2004.
  4. Norton KI. Standards for anthropometry assessment. In: Norton K, Eston R, editors. Kinanthropometry and exercise physiology. 4th ed. London: Routledge; 2018. p. 68-137. doi:10.4324/9781315385662-4
  5. Perini TA, Oliveira GL, Ornellas JS, Oliveira FP. Cálculo do erro técnico de medição em antropometria. Revista Brasileira de Medicina do Esporte. 2005;11(1):81-85. doi:10.1590/S1517-86922005000100009