Skip to content
PounceFit
PTEN

How often to reassess a client and what to repeat

By PounceFit Team · Updated on

Paper planner open to the October pages
Photo: PepedoCouto (CC BY-SA 3.0), via Wikimedia Commons

Technical content for health and fitness professionals. It reproduces formulas and protocols published in the scientific literature, with the sources at the end of the page. It is not a recommendation and does not replace the judgment of the professional who runs the assessment.

There is no fixed interval for reassessment: how often is the professional's decision, based on the client's goal and the error of the method used. What the references ask is that the reassessment repeat the first assessment in everything that is not the client: the same method and protocol, the same assessor, the same device and, in bioimpedance, the same time of day and the same preparation (Heyward and Wagner, 2004; Kyle et al., 2004, part II). Without that, the difference between two assessments may come from the measurement, not the client.

How often should you reassess?

There is no single number. In practice, the interval is usually set in weeks or months, according to:

  • The goal. Body composition changes take time to rise above the measurement error. Reassessing too early tends to show only noise.
  • The method. The larger the method's error, the larger the change needed for it to show up reliably. Skinfold equations are off by about 3 to 4 percentage points of fat against the reference method (Heyward and Wagner, 2004).
  • Your routine. A date set at the assessment itself helps you not lose track of the follow-up.

The starting point for deciding is the error of your own measurement, which you can calculate, as the section below shows.

What to keep the same at reassessment

What to repeat Why
Method (skinfolds or bioimpedance) The methods have different errors, and switching changes the result (Heyward and Wagner, 2004)
Skinfold protocol and equation Different equations give different percentages for the same skinfolds
Assessor A skinfold depends on the site, the caliper and the reading time (Stewart et al., 2011)
Caliper or scale Different devices do not measure the same
Body side ISAK and ACSM standardize the right side (Stewart et al., 2011; ACSM, 2021)
Waist site WHO measures at the midpoint between the last rib and the iliac crest, and ISAK at the narrowest point (WHO, 2011; Stewart et al., 2011)
Bioimpedance preparation and time Fasting, empty bladder, no prior exercise and the same time of day (Kyle et al., 2004, part II)

In bioimpedance, preparation weighs heavily: eating or drinking can lower impedance by 4 to 15 ohms over the following 2 to 4 hours, and right after exercise resistance drops about 3% (Kyle et al., 2004, part II). A reassessment done after a workout and another done fasted do not measure the same thing. Details are in hydration and bioimpedance.

How to know if a change is real: the technical error of measurement

The technical error of measurement (TEM) shows how much the assessor varies when measuring the same thing twice (Perini et al., 2005). To get an assessor's TEM, measure the same skinfolds or girths in a group of people, twice each.

Absolute TEM formula (Perini et al., 2005):

TEM = square root of [ Σd² ÷ (2 × n) ]

Where d is the difference between the first and second measurement for each person and n is the number of people measured.

Relative TEM (%) = (TEM ÷ mean of all measurements) × 100

Worked example

An assessor measures the triceps skinfold of 5 people twice. The differences between the 1st and 2nd measurements were 0.5, 1.0, 0.5, 0 and 1.0 mm, and the mean of all measurements was 15 mm.

  1. Σd² = 0.25 + 1 + 0.25 + 0 + 1 = 2.5.
  2. 2 × n = 2 × 5 = 10.
  3. TEM = square root of (2.5 ÷ 10) = square root of 0.25 = 0.5 mm.
  4. Relative TEM = 0.5 ÷ 15 × 100 = 3.3%.

A 0.5 mm change in this skinfold between two assessments is within the assessor's own error and should not be read as a change in the client. The step-by-step to calculate yours is in technical error of measurement.

What to record so assessments can be compared

A reassessment only repeats the first if the first was well recorded: protocol, device, side measured, waist site, time of day and the client's conditions. The printable body assessment form has the fields in the same order for every assessment. The complete walkthrough is in how to do a complete body assessment, and the sites for each measurement in body circumferences.

In PounceFit, body assessment software, when finishing an assessment the professional picks the date of the next one (30, 60 or 90 days, or another date), and the Compare screen shows two assessments side by side.

Frequently asked questions

How often should I reassess a client?

There is no single interval. The choice is the professional's and depends on the client's goal and the error of the method. What body composition references ask is that each reassessment repeat the method, assessor, device and conditions of the first (Heyward and Wagner, 2004; Kyle et al., 2004, part II).

Can I compare a skinfold assessment with a bioimpedance one?

Not directly. Each method has its own error against the reference method, and the difference between the two results may be just the method (Heyward and Wagner, 2004). Choose one and keep it at reassessments.

How do I know if a small change is real?

Compare the difference with the measurement error. The technical error of measurement (TEM), calculated from repeated measurements on the same person, shows how much the assessor themselves varies (Perini et al., 2005). A difference smaller than that error may be just measurement variation.

Does the time of day of the reassessment matter?

In bioimpedance, yes: ESPEN recommends measuring at the same time of day for repeated measurements, fasted, with an empty bladder and no prior exercise (Kyle et al., 2004, part II). For skinfolds and girths, keeping the same time and preparation also reduces what changes for reasons outside the client.

Sources

  1. Heyward VH, Wagner DR. Applied body composition assessment. 2nd ed. Champaign: Human Kinetics; 2004.
  2. Kyle UG, Bosaeus I, De Lorenzo AD, Deurenberg P, Elia M, Gómez JM, et al. Bioelectrical impedance analysis, part II: utilization in clinical practice. Clinical Nutrition. 2004;23(6):1430-1453. doi:10.1016/j.clnu.2004.09.012
  3. Stewart A, Marfell-Jones M, Olds T, de Ridder H. International standards for anthropometric assessment. Lower Hutt: International Society for the Advancement of Kinanthropometry; 2011.
  4. Perini TA, Oliveira GL, Ornellas JS, Oliveira FP. Cálculo do erro técnico de medição em antropometria. Revista Brasileira de Medicina do Esporte. 2005;11(1):81-85. doi:10.1590/S1517-86922005000100009
  5. World Health Organization. Waist circumference and waist-hip ratio: report of a WHO expert consultation, Geneva, 8-11 December 2008. Geneva: WHO; 2011.
  6. American College of Sports Medicine. ACSM's guidelines for exercise testing and prescription. 11th ed. Philadelphia: Wolters Kluwer; 2021.