Technical content for health and fitness professionals. It reproduces formulas and protocols published in the scientific literature, with the sources at the end of the page. It is not a recommendation and does not replace the judgment of the professional who runs the assessment.
For bioimpedance, the client should arrive fasted, preferably in the morning after a night's sleep, with no alcohol, no exercise in the previous 24 to 48 hours and an empty bladder, and later measurements should be taken at the same time of day (Kyle et al., 2004, part II; Siedler et al., 2023). Food, drink and training change impedance and, with it, estimated fat: a meal lowered bioimpedance-estimated fat by 1.4% to 2.4% on average, and by up to 10% in some people (Tinsley et al., 2017).
Preparation does not make the scale more accurate, but it makes measurements comparable with each other, and that is what allows you to track progress. See why in are bioimpedance scales accurate?
Bioimpedance preparation checklist
| Item | Recommendation | Source |
|---|---|---|
| Food | Fast for at least 8 hours, measure in the morning | Siedler et al. (2023); Tinsley et al. (2017) |
| Fluids | Nothing in the previous 8 hours; 1 liter of water before that period | Siedler et al. (2023) |
| Coffee, alcohol and nicotine | Nothing in the previous 8 hours; avoid alcohol before the measurement | Siedler et al. (2023); Kyle et al. (2004, part II) |
| Exercise | None in the previous 48 hours (ESPEN), or at least 24 hours without intense exercise | Kyle et al. (2004, part II); Siedler et al. (2023) |
| Bladder | Empty before the measurement | Kyle et al. (2004, part II); Siedler et al. (2023) |
| Time of day | Always the same for repeated measurements | Kyle et al. (2004, part II) |
| Menstrual cycle | Note the phase for repeated measurements | Kyle et al. (2004, part II) |
| Skin | Clean where it touches the electrodes | Kyle et al. (2004, part II) |
| Clothing | Minimal | Siedler et al. (2023) |
| Height and weight | Measured on the spot, not reported by the client | Kyle et al. (2004, part II) |
Why food, exercise and water change the result
Food and drink. ESPEN considers fasted or fed state the factor that most affects the result: eating or drinking can lower impedance by 4 to 15 ohms over the following 2 to 4 hours (Kyle et al., 2004, part II). Tinsley et al. (2017) measured 48 men and women fasted in the morning, in the afternoon after eating and again the next morning. The meal lowered impedance by 4.4% and raised estimated body water and fat-free mass by 2%, regardless of diet type. The authors concluded that an overnight fast is probably enough for DXA and possibly enough for bioimpedance.
Exercise. Right after exercise, resistance drops about 3% and reactance about 8%; values return to normal within an hour (Kyle et al., 2004, part II). The ESPEN protocol goes further and asks for 48 hours without exercise. In gym practice, scheduling the assessment before the workout, not after, already avoids the acute effect.
Hydration. The current travels through body water. For this reason, ESPEN does not recommend routine use in people with altered hydration without specific validation (Kyle et al., 2004, part II). To arrive hydrated without drinking right before, Siedler et al. (2023) asked for 1 liter of water before the 8-hour fast. More details in hydration and bioimpedance.
Time of day and cycle. Measuring at the same time of day and noting the menstrual cycle phase reduces differences between assessments that do not come from body composition (Kyle et al., 2004, part II).
How to measure with a bioimpedance scale
After testing 15 devices, Siedler et al. (2023) suggested the following for people using a scale:
- Follow a preparation protocol: measure in the morning, right after the overnight fast, with an empty bladder and minimal clothing.
- Track the average of several days, not a single measurement.
- Always use the same device and interpret the change in light of its error.
The same authors noted that some scales seemed to avoid giving different numbers when the same person repeated the measurement within a few minutes with the same registered user. To check a scale's repeatability, repeating the weigh-in right away is not enough.
When not to do bioimpedance
- Pacemaker or defibrillator. ESPEN does not expect interference and knows of no incidents, but does not rule out the possibility and asks for cardiac monitoring (Kyle et al., 2004, part II).
- Extreme BMI or altered hydration. Routine use is not recommended without specific validation (Kyle et al., 2004, part II).
- Metal implants. Record them on the form (Kyle et al., 2004, part II).
How to brief the client before the assessment
Send the instructions when you book and confirm on the day: fasting, exercise, bladder and time of day. If the client arrives outside the protocol, record the deviation or reschedule, so you do not mix a nonstandard measurement into the history. In PounceFit, the bioimpedance scale has its own history, separate from skinfolds, which keeps the comparison between measurements taken the same way. To understand what the scale measures, see bioelectrical impedance: what it is and how it works and bioimpedance with 4 or 8 electrodes.
Frequently asked questions
Do you need to fast for a bioimpedance test?
Yes. Eating or drinking can lower impedance by 4 to 15 ohms over the following 2 to 4 hours (Kyle et al., 2004, part II). In one study, a meal lowered impedance by 4.4% and lowered estimated fat by 1.4% to 2.4%, with individual drops of up to 10% (Tinsley et al., 2017). An overnight fast with the measurement in the morning is the simplest approach.
Can you drink water before a bioimpedance test?
Drinking right before changes the reading. In the protocol of Siedler et al. (2023), participants drank 1 liter of water before starting 8 hours without food or fluids, to arrive hydrated, and had nothing more to drink until the measurement.
How long should you avoid exercise before a bioimpedance test?
ESPEN recommends no exercise in the previous 48 hours, with shorter periods accepted in practice (Kyle et al., 2004, part II). Siedler et al. (2023) used 24 hours without exercise or intense physical activity. Right after exercise, resistance drops about 3% and reactance about 8%.
Does coffee affect bioimpedance?
In the protocol of Siedler et al. (2023), coffee, alcohol and nicotine were withheld for the previous 8 hours, along with food and fluids. ESPEN asks for no alcohol before the measurement (Kyle et al., 2004, part II).
Can someone with a pacemaker have a bioimpedance test?
ESPEN says no interference is expected and there are no known incidents, but the possibility cannot be ruled out, and it asks for cardiac monitoring in these cases (Kyle et al., 2004, part II). Outside a clinical setting, the safer choice is not to measure and to record the reason.
Sources
- Kyle UG, Bosaeus I, De Lorenzo AD, Deurenberg P, Elia M, Gómez JM, et al. Bioelectrical impedance analysis, part II: utilization in clinical practice. Clinical Nutrition. 2004;23(6):1430-1453. doi:10.1016/j.clnu.2004.09.012
- Siedler MR, Rodriguez C, Stratton MT, Harty PS, Keith DS, Green JJ, et al. Assessing the reliability and cross-sectional and longitudinal validity of fifteen bioelectrical impedance analysis devices. British Journal of Nutrition. 2023;130(5):827-840. doi:10.1017/S0007114522003749
- Tinsley GM, Morales E, Forsse JS, Grandjean PW. Impact of acute dietary manipulations on DXA and BIA body composition estimates. Medicine and Science in Sports and Exercise. 2017;49(4):823-832. doi:10.1249/MSS.0000000000001148
